Ham Radio Forum

HI,

i got TX & Rx module for HT 12e/d chip data transfer serially ,
i don't have oscilloscope to check its output waveform pls tell any method to check it........







Thanks

reply...........pls

Unless you have a receiver that can be tuned to 433 MHz to hear the signal, about the only thing you can do is test communication between two 433 MHz transmit/receive modules.

jm

Hi,

MY Rx & Tx are working fine, with holtek 12E/D..........
I want to know what is diff. b/w linear data & digital as in digital it is 0,1's but in case of linear??


Ritesh

I have never used the Holtek 12E digital code transmitter/receiver system. However, maybe you could measure the linearity by integrating the data output from its Data Select & Buffer using a simple R/C integrator and then watch the resulting integrated DC voltage change on a voltmeter as you step through A0 through A11 input codes.

Andy

OK, what type of signal can i transfer from this TX & RX, can i transfer audio signal from this??

How to transfer audio signal of amplifier to Tx to Rx...........??